| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Mechanical | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002BOF00FX |
| Title: 2UZ-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. INSTALL FAN AND GENERATOR V BELT
|
(a) Set the V belt onto every part except the No. 2 idler pulley, as shown in the illustration. |
(b) Loosen the V belt by turning the belt tensioner counterclockwise.
(c) Set the V belt to the No. 2 idler pulley.
|
(d) After installing the belt, check that it fits properly in the ribbed grooves. |
(e) Check by hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley.
|
(f) Check that the arrow on the belt tensioner is within area "A". If it is outside area "A", replace the fan and generator V belt. HINT:
When a new belt is installed, the arrow should be within area "B". If not, the fan and generator V belt is not installed correctly. |
2. INSTALL AIR CLEANER HOSE ASSEMBLY
3. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY
4. INSTALL NO. 1 ENGINE UNDER COVER
|
|